Loading the content...
Navigation
Account
Cart 0 items for $0.00

No products in the cart.

CMC Hydraulic Jack Plate

‹Return to Previous Page
Description

Description

CMC Hydraulic Jack Plate

Features Of Patented Hydraulic Power-Lift® 

  • Made of 6061 T6 alloy aluminum extrusions and fastened with stainless steel fasteners. Ideal for fresh or salt water use. No welds or castings to break.
  • It contains a permanent magnet motor for more power and constant torque. The cylinder within the actuator has twice the lifting capacity than other transom jacks on the market. It contains a no-leak seal and wiper that keeps dirt and water out of the working parts. The system is made of 100% non-ferrous material which makes it impervious to saltwater and freshwater.
  • The patented roller design means less friction, longer wear, less maintenance, and virtually no binding problems which are common with other transom jacks. The roller assembly contains a stainless steel 3/4″ pin with aluminum-bronze alloy rollers. The roller is highly impact resistant, corrosive resistant, and has a high load carrying capacity. This patented design virtually eliminates any chance of binding which is common with other transom jacks.
  • The PL-65 is rated for V-6 motors and smaller and gives you 5″ of vertical travel with 1-1/2″ of adjustment on the motor bracket and 1-1/2″ of adjustment on the transom bracket. A total of 8” of possible adjustment.

 

Transon Support Plates and Wedges

Transom Support Plates / Transom Washer Plates

Made of strong 3/8" 6061 T6 alloy aluminum (not cast aluminum), the CMC transom washer can eliminate bolts “biting” into transoms and can more evenly distribute loads on high performance engines.

Hole centers: Top Plate – 12 7/8" Bottom Plate – 9 7/8"

_____________________________________________________

CMC Transom Wedges and Setback Spacers (Item #20122)

These 2 degree wedges are designed to give extra positive or negative trim.

Features:

  • Used as an aid for boats with an insufficient transom angle or for boats having planing problems at low speed
  • Unique design of the CMC Transom Wedges allows you to also use them as set back spacers
  • Simply stack and invert 2, 4, and 6 sets (sold in sets of two)
  • Fit all Transom jacks, jack plates, Outboard lifts, tilt trim units, and outboard motors with a standard B.I.A bolt pattern
  • Made of strong 6061 T6 alloy aluminum (not cast aluminum)

Related Products

Back to top