Dock Fenders for all sizes of vessels.
Showing all 5 results
Aluminum Fender Brackets from Boaters Catalog.
When pilings are not available for mounting the fenders necessary to protect your vessel, fender brackets are an inexpensive alternative to installing pilings and not as unsightly.
Made of marine grade 6061 structural aluminum I-beams and aluminum plate, these TIG welded braces can be made to accommodate almost any situation.
- Standard channel width is 4 inches to accommodate nominally sized 4x4 lumber.
- Standard sizes are one foot and three foot
- Custom Lengths are available
When used on larger vessels, for maximum protection and strength, the fenders should not extend above or below the braces more than 12", unless supported from behind by a bulkhead or lower piling.
For mid sized to smaller vessels, the standard mount should only extend above or below the mounting point no more than 4 feet and still may need either a backing bulkhead, piling, or other dock support behind the long section or an extra large gusset that will take longer to manufacture at an addition cost.
Call us for a price quote on the braces you need at 1-800-745-0765
Quality Flexmaster Corner Mount or Concrete Piling Fender for your dock from Boaters Catalog
- Used to protect corners on concrete piling or any 90 degree angle
- Up to 12’ long The price of the mounted Corner Mount Bumpers is per foot(mounted on 2x4 recycled plastic) .
Enter the number of feet you want in the quantity box below.
Shipping will be quoted by e-mail or telephone after order is placed or you may call 800-745-0765 for a quote
Our superior Flexmaster Dock Fender from Boaters Catalog is available in black or white.
- Extruded from a special poly vinyl chloride compound
- Black will not mark boat
- Designed to mount to any 2" x 4" or 4" x 4”
Purchase the Flexmaster Fenders by the total number of feet you need. If you need it cut into specific lengths, tell us in the notes at check out what lengths you need.
All Flexmaster freight will be quoted by e-mail or telephone at time of purchase. The shopping cart will not add freight for this product to your order. You may call 800-745-0765 for a quote.
Flexmaster Single Leg Mount Fenders from Boaters Catalog
These fenders are cut to order, up to 12' long,
The single leg mount is meant to be installed horizontally with the nailed leg up.
Picture shows Fender mounted, but they are sold un-mounted by the foot or mounted by the foot. Enter the number of feet you want in the "quantity" box below.
All freight will be quoted by telephone or e-mail after the order is received or call 800-745-0765 for a quote.
Our Stainless Steel Ring Shank Large Head Nails from Boaters Catalog are sold by the pound, approximately 110 nails per pound. These 316 stainless steel nails are recommended to install your rub rails and piling caps. They are 1-1/2" long with a large head and ring shank to eliminate backing out. Use one per 6" appx. on rub rails and 4 to 6 on piling caps. You should use the nails on both top and bottom nailing strips of either bumper. (one pound of nails should be enough for one 25 foot strip of bumper)